Track Clips are used to fasten stems to the back of track. The clips can be used with a track groove in the extrusion or mounted flush to the back of the track.  Click here to view a line drawing of the Track Clip Kit.

Track Clip Bases can be viewed here.

*”IP” is trade size, not the diameter. Reference below for Diameters

• 1/8″ IP = .375″-.380″ (3/8″)
• 1/4″ IP = .500″-.510″ (1/2″)
• 3/8″ IP = .625″-.635″ (5/8″)
• 1/2″ IP = .800″-.810″ (3/4″)

Track Clip Pendant

• Track Clip Kit 1/4 Drawing
• Track Clip Kit 1/4-.3 Drawing
• Track Clip Kit 1/4-.5 Drawing
• Track Clip Kit 1/4-1 Drawing
• Track Clip Kit 1/4-1.1 Drawing
• Track Clip Kit 3/8 Drawing
• Track Clip Kit 3/8.3 Drawing
• Track Clip Kit 3/8-.5 Drawing
• Track Clip Kit 3/8-1 Drawing
• Track Clip Kit 3/8-1.1 Drawing

Track Clip Grippers

• TC- .380 Mounting (10/32)
• TC- .5 Mounting (1/4-20)
• TC-1 Mounting (1/4-20)
• TC-1.1 Mounting (1/4-20)

Track Clip Gripper Uses

1. Feed
   • Feed J-Box Mount SE TC-1 12/3
2. Non-Feed
   • Non-Feed CC1/8 SO Mount SE TC-1
   • Non-Feed Loop End SE TC-1
   • Non-Feed Sheetrock Mount SE TC-1

Track Clip Sets

PS Part#	Individually Bagged with 1-TC-Base (.966″ width)
1-TC 3/8 or 1/4 (1.0″ width) & 2-#217 Screws
Track Clip Kit 1/4″	1/4″ IP Threaded Top Plate for 1/4″IP Stems (1/2″OD)
Track Clip Kit 3/8″	3/8″ IP Threaded Top Plate for 3/8″IP Stems (5/8″OD)